Install The Battery Pack; Remove The Battery Pack; Operation; Start The Machine - GreenWorks BLG301 Guide De L'opérateur

4. Align the hole (6) on the front tube with the tab (7)
on the rear tube.
5. Install the front tube onto the rear tube until the tab
locks into the position.
9.3

INSTALL THE BATTERY PACK

WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
9.4

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
5
4
7
6
English
10

OPERATION

Make sure the blower tube is in position before
operation.

10.1 START THE MACHINE

3
1. Pull the trigger (1) to start the machine.
2. Pull the trigger to increase the speed.
3. Release the trigger to decrease the speed.

10.2 STOP THE MACHINE

1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.

10.3 OPERATION TIPS

• Blow around the outer edge of the unwanted
materials to prevent the unwanted materials from
scattering.
• Use rakes and brooms to clear the unwanted
material before you blow.
• Make the surfaces wet before you clear the
unwanted material in dusty conditions.
• Look out for children, pets, open windows, and
cleaned cars during operation.
• Clean the machine.
• Discard the unwanted material when you complete
work.
11

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
7
WARNING
1
2
NOTE
CAUTION
EN