Final Check-List - Brevi Tao b.fix Notice D'emploi

raise the headrest: simply pull the handle located
on the upper part of the back of the headrest. To
lower the headrest: use the lever (Pic.27) on the
rear of the backrest, moving it downwards until it
is properly adjusted. Release the lever to lock the
headrest in the desired position. Always ensure
the safety harness is taut, pulling the diagonal part
upwards and make sure it is not twisted. If the
safety harness comes into contact with the child's
neck or if it does not pass above their shoulder,
adjust the height of the headrest as described in
Pic. 27. Always make sure the safety harness is
taut and that all extra belt is wound up by the reel,
by moving the diagonal part upwards.
Notes: To better protect your child
Make sure your child is securely fastened in the
safety seat and the harness snugly fits over his/
her body. Never leave your child unattended in
the safety seat or in the vehicle. When installing
your child on the rear seat of the vehicle, move
the front seat forward far enough to avoid his feet
hitting the backrest of the front seat (this may also
prevent risk of injury, in the case of an accident).
When entering in or exiting your child from the
vehicle, do it only on the safe side of the street,
away from traffic.

FINAL CHECK-LIST

• Check that the harness shoulder straps are
in the correct position for your child, firm-
ly and comfortably fit on your child's body.
• Check that the vehicles seat belt is correctly fit-
ted around the child car seat.
• Check that the vehicle's seat belt has not beco-
me twisted or trapped in any way.
• Make sure all of the child car seat harnesses are
properly adjusted and taut.
• Make sure the buckle of the child car seat's har-
ness group is always properly fastened.
• Check that the buckle on the child seat safety
harness is correctly locked.
• Check that the chest pads are always in the right
position on your child's body.
• Check regularly all important parts for possible
damage.
• Check the correct operation of all components.
• Check that the child seat does not get jammed in
the car door, seat runners, etc., in order to pre-
vent breakage, damage, wearing etc..
• Make sure that both Isofix connectors are posi-
tioned and fastened properly.
Remember: No matter how well a child car
seat has been designed, if it is fitted in the vehicle
incorrectly then it may fail to protect your child in
the event of an accident. Before travelling using a
Tao b.fix child child car seat, always carry out the
final checks listed in this instructions booklet.
Warning:
Any child seat tightly fixed on the vehicle seat may
leave signs, due to the measures to be adopted
in compliance with the Safety Standards. This
35