Short Cord Instructions - Krups Aquacontrol FLF2 Mode D'emploi

Masquer les pouces Voir aussi pour Aquacontrol FLF2:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11. For all models : to disconnect, switch-off the appliance and then
remove plug from wall outlet. Never yank cord to disconnet
from outlet, instead grasp plug and pull to disconnet. For
corded models : always attach the plug to the appliance first,
then plug the cord into the wall outlet.
12. Do not place the base of your kettle in a metal tray. If water
spills over into the tray and a build-up occurs, it could become
dangerous to touch.
13. Before pouring, wait until the kettle has stopped boiling and
then pour steadily. If the kettle is tipped too much, the lid may
fall off or open.
14. Never lift the lid of the kettle while water is boiling.
15. WARNING : a cordless kettle must never be filled on its base.
16. Your Krups appliance is intended for household use only.
17. This is a 1750 watt appliance. To avoid a circuit, do not operate
a high wattage appliance on the same circuit.

SHORT CORD INSTRUCTIONS

a. We do not recommend using an extension cord with this
device.
b. If an extension cord is absolutely necessary the marked
electrical rating should be at least as great as the electrical
rating of the appliance. Cords rated for less amperage may
overheat. Care should be taken to arrange the cord so that it
cannot be pulled or tripped over. If appliance is the grounded
type, the extension cord should be a grouding type 3-wire cord.
c.
This appliance may have a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this plug is
intended to fit into a polarized outlet only one way. If it does
not fit, contact a qualified electrician. Do not attempt to modify
the plug in any way.
Bouilloire US/F/E .PM6.5
SAVE THESE INSTRUCTIONS
5
20/09/04, 15:49
5

Publicité

Table des Matières
loading

Table des Matières