Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Technical specifications
power
- power consumption in watts
- Of which lighting (LED)
- Voltage in volts
- Fan volume max.
Dimensions
- Height in cm
- Width in cm
- Depth in cm
- Exhaust outlet in mm
- Net weight in kg
specifications
- Built-in hood for installation in a cabinet
- Connection with safety plug
- 3-level control
- LED lighting (2x 3W)
- grease filter (dishwasher-safe)
- Suitable for recirculation and exhaust air
safety instructions
power supply
The connection is made via a fixed cable with earthing contact plug.
In the case of a required permanent connection, the hood may only be installed by an electrician,
registered at the responsible electricity supply authority.
On the installation side, a disconnecting device (this includes fuses, contactors and circuit breaker
acc. VDE 0730, §7, Part 1) has to be used.
Use in exhaust mode
In order to ensure optimal operation with exhaust air, we recommend implementation of the following
activities
- Short, straight tube guide
- As few pipe bends as possible
- Laying the pipes in flat bends and avoiding sharp angles
- The largest possible pipe diameter
Failure to comply with these points may result in drastic loss of performance and possible raise of
operating noise. This is not to be regarded as a malfunction of the device.
In addition, it is in any case inadmissible to blow the exhaust air in otherwise used chimneys or other
kinds of culverts. It should only be used for the air of the cooker hood.
If the exhaust air is discharged into a non-operational chimney, we recommend to obtain approval of
the responsible chimney sweeper.
226W
2x 3W
220-240V
1000m³ / h
25cm
60cm
30-45cm
ø150mm
approximately 7.3kg
Publicité
Table des Matières
