Keg King Fermentasaurus Manuel D'utilisation page 17

EN
Fermentasaurus Uni Tank
FERMENTASAURUS GRAVITY LID ASSEMBLY
1. Sanitize all components prior to assembly.
2. Lubricate the NBR Lid Seal with some food-grade lubricant.
3. Attach the NBR Lid Seal to the underside of the Gravity Lid.
4. Once the seal is firmly seated on the underside of the gravity lid place them
both on top of the neck of the fermenter.
5. Lubricate the outer edge of the top surface of the lid with some Vaseline or
food-grade lubricant.
6. Place the top thread ring over the lid and tighten in the clockwise direction.
Overtightening may make it difficult to undo later.
7. Place the three-piece airlock into the hole at the top of the gravity lid.
No grommet or seal is required. Simply press the airlock firmly into the hole.
32 OPERATING INSTRUCTIONS
Three-Piece Airlock
(Glass Reinforced Nylon)
#RET0054
Top Thread Ring
(Glass Reinforced Nylon)
Sold with gravity lid assembly
#009197
Gravity Lid
(Glass Reinforced Nylon)
(only sold with gravity lid
assembly #009197)
Lid Seal
(NBR)
#009265
Fermentasaurus Uni Tank
FERMENTASAURUS PRESSURE LID ASSEMBLY
1. Sanitize all components prior to assembly.
2. Thread the red pressure release valve into the pressure lid.
3. Ensure that the gas and liquid bulkhead fittings are correctly assembled with the
post fully tightened onto the bulkhead body. Insert the bulkhead fittings into the
holes in the pressure lid and tighten the locknuts. O-rings should be located on the
top surface of the lid for correct sealing.
4. Lubricate the silicone dip tube with some sanitizer and slide one end onto the stem
of the liquid post bulkhead fitting. Slide the other end of the silicone tube onto the
floating pickup.
5. Lubricate the entire NBR Lid Seal with some food-grade lubricant and fit to the
underside of the Gravity Lid.
6. Place the pressure lid on the mouth of the Fermentasaurus and ensure that the seal
seats correctly.
7. Put a small amount of Vaseline or food-grade lubricant on the top
8. Place the top thread ring over the lid and tighten firmly.
EN
OPERATING INSTRUCTIONS 33