Keg King Fermentasaurus Manuel D'utilisation page 15

EN
Fermentasaurus Uni Tank
WARNINGS
1. Only wash the fermenter with cold water. Do not clean, wash or sanitize the
fermenter with water that is above 50°C (122°F).
2. Under no circumstances apply more than 2.4 bar (35psi) to the
Fermentasaurus Uni Tank.
3. NEVER connect an unregulated pressure source.
4. If you connect an external pressure source; ensure it has independent
pressure release valve (PRV) pre-set to below 3.0 bar (43.5 psi).
5. Only use the RED pressure release valve supplied by Oxebar Pty Ltd on the
fermenter lid.
6. Do not tamper with the pressure relief valve.
7. If the fermenter is scratched, damaged or has been subjected to any physical
duress, do not use the fermenter under pressure.
8. Do not expose to temperatures below -2°C/28.5°F.
9. Keep the fermenter out of direct sun or heat.
10. Avoid exposure to ultraviolet radiation.
11. The Fermentasaurus body is pressure tested at production and is marked with
a date for retesting. If the fermenter is being used under pressure; then the
fermenter must be hydro tested every 24 months to ensure it is safe to use. As
an alternative to hydro testing; a replacement PET body for the fermenter can
be purchased from Fermentasuarus distributors.
12. Only use chemical cleaners and sanitizers that are approved by Oxebar.
Cleaners must be diluted to suitable strengths before use. If extended contact
time is expected, then users must ensure that cleaners are chemically
compatible with PET, NBR, EPDM, Nylon and Stainless Steel. Possible
cleaning/sanitizing agents include:
a. Diluted Phosphoric Acid Based Sanitizers (diluted to no rinse strength, e.g.
15 ml per 10 l)
b. Diluted Peroxide Based Cleaners (e.g. 1 teaspoon Sodium Percarbonate per
litre of water)
c. Sodium Metabisulfite or Campden tablets
d. Sodium Hydroxide solution (<20 g NaCl per litre of water)
28 OPERATING INSTRUCTIONS
Fermentasaurus Uni Tank
FERMENTASAURUS GRAVITY KIT
EN
3 Piece airlock
Part #RET0054
Gravity Lid Assembly
(Thread Ring, Lid, NBR Seal,
Glass Reinforced Nylon)
#009197
Fermentasaurus 35 l Tank
(High IV Low Crystallinity PET)
#009142
304 Stainless Frame
(6 mm Round Rod)
#009142
Butterfly Dump Valve Assembly
(Machined 304 stainless gate,
stainless bolts, Glass Reinforced
Nylon, EPDM Gate Seal,
NBR Conical seal)
#009159
500 ml Collection Bottle with Lid
(PET, ABS Cap with silicone Seal)
#009180
The Fermentasaurus Starter Kit
includes all the components
in the above image.
OPERATING INSTRUCTIONS 29