Keg King Fermentasaurus Manuel D'utilisation page 16

EN
Fermentasaurus Uni Tank
FERMENTASAURUS DUMP VALVE ASSEMBLY
1. Ensure that all components have been sanitized.
2. Check that the two NBR seals (O-ring and cone seal) are attached to the spigot.
The O-ring is placed in a recess on the bottom face of the spigot; the cone seal
slides over the threaded portions of the spigot and rests on the tapered section.
3. Carefully drop these parts into the top of the fermenter neck. The threads
should slide through the hole in the bottom of the fermenter. If the threads
are not protruding through the bottom, you will need to re-orientate
the component; tap or shake the fermenter to realign.
Dump Valve Spigot
(Glass reinforced nylon)
(only sold with dump valve
assembly #009159)
30 OPERATING INSTRUCTIONS
Spigot Seals
(NBR)
Two components including:
Spigot O-ring
Spigot Cone Seal
(sold with butterfly dump valve
seal kit #009166)
Fermentasaurus Uni Tank
4. With the spigot threads protruding from the base of the fermenter, you can now
screw the spigot nut onto the spigot. Ensure the axis of the spigot and fermenter
are correctly aligned and then tighten firmly. The spigot can accept a 19 mm
(or a ¾") hex (Allen) key. NOTE: This is a LEFT-HANDED THREAD.
5. Ensure the spigot O-ring is still pushed into the seat on the bottom face of the spigot.
6. Check that the O-ring on the underside of the valve is in place. This ensures cor-
rect sealing with the collection bottle.
7. Screw the Butterfly Valve onto the Dump Valve Adaptor. Not much force is r equired
to compress the O-ring and form a seal. NOTE: This is a RIGHT-HANDED THREAD.
8. You should now fill the fermenter with water or sanitizer and check that there are
no leaks. If you do find a leak; loosen off the spigot nut, realign assembly with
fermenter and retighten all components.
9. If you do not have access to a suitable hex key for assembly, then you can hold the
Spigot Nut in one hand and the Butterfly valve in the other and tighten. The opposite
handed threads will cause both the cone seal and the O-ring to compress and seal.
NOTE: Using this method to tighten can make later d isassembly more difficult.
EN
Spigot Nut
(Glass Reinforced Nylon)
(only sold with dump valve
assembly #009159)
Butterfly Valve Assembly
(304 Stainless Gate, Stainless
Screws, EPDM Gate seal, Glass
Reinforced Nylon)
(only sold with dump valve
assembly #009159)
Butterfly Valve Handle
(Glass Reinforced Nylon)
(only sold with dump valve
assembly #009159)
Dump Valve Assembly
(Combination of above
components)
#009159
OPERATING INSTRUCTIONS 31