Codes D'installation - Sierra Flame BRADLEY-NG Manuel D'installation Et Guide De L'utilisateur

19,000 btu gaz naturel
Table des Matières

Publicité

APPLIANCE DIMENSIONS
Figure 1
24.00"
14.00"
14.50"
0.50"
34.00"
15.00 "
29.00"
32.50"
16.38"
25.50"
36.000"
INSTALLATION CODES
This appliance is a Direct Vent appliance which draws all combustion air from outside the building
through an intake vent pipe.
Installation must conform to local codes. In the absence of local codes, installation must conform to
the National Fuel Gas Code ANSI Z223.1/NFPA 54, or the current Natural Gas Installation Code CSA
B149.1. The unit, when installed, must be electrically grounded in accordance with local codes or, in
the absence of local codes, with the National Electric Code ANSI/NFPA No.70 or with the current
Canadian Electrical Code CSA C22.1. In the state of Massachusetts, this product can only be
installed by a licensed plumber or a licensed gas fitter. Failure to comply will void the warranty.
This appliance has been certified for use with natural gas.
This appliance is not for use with solid fuels.

CODES D'INSTALLATION

Cet appareil est un appareil à évent direct, qui attire tous l'air de combustion provenant de l'extérieur
du bâtiment par une entrée d'évent.
L'installation doit se conformer aux codes locaux. En l'absence de codes locaux, l'installation doit
être conforme au National Fuel Gas Code ANSI Z223.1/NFPA 54, ou le gaz naturel actuel et le Code
d'installation CSA B149.1. L'unité, une fois installé, doit être électriquement à la terre conformément
aux codes locaux ou, en l'absence de codes locaux, avec le National Electric Code ANSI / NFPA
No.70 ou avec l'actuel Code canadien de l'électricité CSA C22.1
Cet appareil a été certifié pour une utilisation avec du gaz naturel.
Cet appareil n'est pas pour une utilisation avec des combustibles solides.
Page 7 of 45

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lc773211

Table des Matières