Table des Matières
Publicité
3.3.3 DIRECT VENT INFORMATION CONT
VENT RESTRICTOR INSTALLATION
VENT RESTRICTOR
To fasten the Restrictor Plate to the ceiling of the firebox:
1/. Remove the 2 screws that are in place
2/. Align holes in the Restrictor that match the required degree of restriction
3/. Fasten Restrictor Plate back in place.
DIRECT VENT TERMINATION
TERMINATION
CAP PART # 1032
The above termination cap is the only certified cap to be used with this venting configuration. No
other termination cap may be used.
Vent Configuration Restrictor Size
60%
40%
20%
RESTRICTOR PLATE
Page 22 of 45
Publicité
Table des Matières
