Moulinex i-Companion XL Mode D'emploi page 146

PROBLEMS
EN EN
Leak through lid.
Leak through the bowl
spindle or by the XL bot-
tom accessory.
The blades do not rotate
easily.
Smell from motor.
"STOP" is displayed.
"SECU" is displayed.
"SECU" is displayed + red
indicator light is flashing.
"Err1" is displayed.
+ red indicator light is
flashing.
"Err2" is displayed.
"Err3" is displayed.
"Err4" is displayed.
Displays «Err8»
"ntc1" is displayed.
+ red indicator light is
flashing.
"ntc2" is displayed.
+ red indicator light is
flashing.
CAUSES
Volume of ingredients too high.
The lid is incorrectly positioned or locked.
The lid seal is not present.
The seal is cut or damaged.
Accessory error.
The bowl seal is not correctly positioned. Position the seal correctly.
The bowl seal is damaged.
The locking ring (D6) is not locked correctly. Lock the ring correctly (D6).
Pieces of food that are too big or too
hard are blocking it from rotating.
On using the appliance for the first time, or
in the event of overload of the motor caused
by too large a quantity of ingredients or by
pieces that are too hard or too big.
The appliance has detected too many
vibrations and has changed to the safety
mode.
Motor overload caused by too many in-
gredients or pieces which are too hard or
too large or overuse without sufficient
cooling down time.
Overheating of temperature sensors.
The heating element is not working.
Electronic fault.
Speed fault.
Communication fault with chopper
electronic card.
Default security sensor lock.
Temperature sensor 1 is no longer
working.
Temperature sensor 2 is no longer
working.
139
Reduce the quantity of ingredients
processed.
Lock the lid correctly on the bowl.
Position the seal on the lid.
Change the seal, contact an approved
service centre.
Check that you are using the recom-
mended accessory.
Contact an approved service centre.
Reduce the size or quantity of the
ingredients processed. Add some liquid.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Check that you are using the right speed
and that you are using the recommended
accessory.
Allow the motor to cool down (about
30 minutes) and reduce the number of
ingredients in the bowl.
Contact an approved service centre.
Check that the power pins under the bowl
are not clogged with food. If this is the
case, clean them and try again.
If that still does not work, contact an
approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
Contact an approved service centre.
139
SOLUTIONS