Operating The Appliance - Thomas INOX Série Notice D'utilisation

Assembly Instructions
Dear client,
The THOMAS wet & dry vacuum cleaner
will give excellent cleaning results
throughout your home and workshop.
The Wet & Dry models INOX 1420 plus/1520 plus
and INOX 1520 S are delivered with a 20-liter
stainless-steel dirt collecting bin, and enhanced
motor casing with protection against splash water.
Assembly Instructions
A Assembling the chassis
The parts to be assembled are supplied loose
for packing reasons . Open the snap fastener
and lift up the motor head .
Place the container with opening facing
downwards . Insert the steering castors
with bolts in the drill holes marked with the
number 4 and press in the bolts up to the
stop . Make sure that one steering castor
is directly in line under the suction intake
opening .
B Fitting the motor block
Place the motor block onto the collecting bin,
making sure that the operating switch lies
directly in line with the middle of the suction
socket . Lastly, secure the motor block by
means of both snap fasteners .
C Connecting the flexible hose
Connecting the flexible hose . Remove the
hose by turning the hose connecting piece
and withdrawing the hose .
Assemble the accessoires you require .
Connect the main cable .

Operating the appliance

The Appliance is switched on and off by
means of the switch located on the motor
block casing .
The mains supply voltage must correspond to
the voltage given on the rating plate .
10
D Changing the cartridge filter
(Optional extra, Part no . 787021/421)
Pull out the plug!
Undo the snap fasteners, remove the motor
block from the collecting bin and turn over .
Secure the cartridge filter by the pre-mounted
retaining clips .
Place the new cartridge filter in an upright
position on the motor flange and gently
but firmly slide it into place on the filter
mounting . The pre-mounted retaining clips
automatically snap into place, thus securing
the cartridge filter . Place the motor block
on the collecting bin again and secure by
means of the snap fasteners .
E Inserting the paper filter bag
(when changing the paper filter bag)
+
Place the filter bag inside the collecting bin,
F
making sure that the opening located in the
cardboard inlay is placed in line with the
suction socket .
Then press the filter bag evenly
around the sides of the collecting bin.
Thomas paper filter bags are essential
when vacuuming fine dust, e .g . soot, ashes,
sawdust or cement . However, they are also
recommended for normal use, as they not
only improve the retention of dust, but also
make filter changes more hygienic .
Changing the cartridge filter
Gently pull the retaining clips back in the
direction indicated and carefully remove the
cartridge filter in an upright position from the
filter mounting .