Operating The Appliance - Thomas INOX 1545 S Notice D'utilisation

Assembly instructions
Dear client,
thank you very much for your confidence.
You have made the really good choice:
The powerful Thomas INOX 1545 S und
INOX 1545 SFE wet and dry multicleaners with
45 litre stainless steel tank, 2-stage heavy-
performance turbine and a splash water-proof
suction unit are true helpers in dealing with all those
cleaning jobs in your hobby workshop, cellar and
garage.
If this appliance brings you entire satisfaction, we would
be grateful to you to recommend us.
We prefer this sort of promotion to a big luxurious
advertising campaign.
A Assembling the transport handle
Slide the transport handle from above into the
fixtures provided and screw securely into place.
B Fitting the motor block
Place the motor block onto the collecting bin,
making sure that the operating switch lies directly
in line with the middle of the suction socket. Lastly,
secure the motor block by means of both snap
fasteners.
C Connecting the flexible hose
Firmly insert the flexible hose in the suction socket
and turn the hose until the button clicks into place
and the markings on both the suction socket and
the hose connecting piece correspond. (Remove
the hose by turning the hose connecting piece and
slowly withdrawing the hose).
Then attach the desired accessories and the
appliance is ready for use.

Operating the appliance

The MultiVac is switched on and off by means of
the switch located on the motor block casing.
The mains supply voltage must correspond to the
voltage given on the rating plate.
D Changing the cartridge filter
Pull out the plug!
Undo the fasteners, remove the motor block from
the collecting bin and turn over.
Gently pull the retaining clips back in the direction
indicated and carefully remove the cartridge filter
in an upright position from the filter mounting.
Place the new cartridge filter in an upright position
on the motor flange and gently but firmly slide it
into place on the filter mounting.
10
The pre-mounted retaining clips automatically snap
into place, thus securing the cartridge filter. Place
the motor block on the collecting bin again and
secure by means of the snap fasteners.
E Inserting the paper filter bag
Place the filter bag inside the collecting bin, making
sure that the opening located in the cardboard
inlay is placed in line with the suction soket.
F The unit is fitted with a socket for external
appliance.
Electrical devices with wattages between
60 – 2000 W can be connected here.
Model 1545 SFE
The 1545 SFE model has two operating modes,
selected by means of selector switch 15 on the unit.
Selector switch 15
N: Normal operating (manual)
Immediate start-up of general purpose vacuum
cleaner for all cleaning tasks.
A: Automatic operation
The red light indicates that the appliance is ready
for operation.
Select this mode of operation when an electrical
tool fitted with a dust extraction device is to be
connected to the vacuum cleaner.
Connect the electrical tool to the coupler socket on
the vacuum cleaner and attach the suction hose to
the appropriate outlet located on the tool.
Now, when the electrical tool is switched on/off,
the vacuum cleaner will function simultaneously.
The electronic switch-on control is suitable for
electrical tools with a power input of 60 – 2000
Watts maximum.
G
Changing the filter: model 1545 SFE
Firstly loosen the locking lever and pull the retainer
to the side. Remove straightly the filter cartridge
immediately. Fit a new or cleaned filter cartridge
onto the motor flange and push along the filter
rail as far as it will go. Finally, re-secure with the
retainer and locking lever.
H Accessory case
Hang the accessory case onto the handle with both
eyelets at the top.