AirDesign UFO 2 Manuel D'utilisation page 67

Ground-handling
•
Choose a suitable area to launch your glider. Lines caught on roots or rocks lead to
unnecessary strain on the attachment tabs during inflation. Snagging lines may rip
the canopy fabric or damage lines.
•
When landing, never let the canopy fall on its leading edge. The sudden pressure
increase can severely damage the air-resistant coating of the canopy as well as
weaken the ribs and seams.
•
Dragging the glider over grass, soil, sand or rocks, will significantly reduce its lifetime
and increase its porosity.
•
When preparing for launch or when ground-handling, be sure not to step on any of
the lines or the canopy fabric.
•
Don't tie any knots in the lines.
This glider will remain airworthy and in good condition for many years, if well cared for and
packed correctly.
Storage
•
Avoid packing your glider when it is wet. If there is no other way, then dry it as soon
as possible away from direct sunlight and heat. Be careful to avoid storing your
canopy when damp or wet: this is the most common reason for canopy degradation.
•
Do not let your glider come into contact with seawater. If it does, rinse the lines,
canopy and risers with fresh water and dry it away from direct sunlight before
storing.
•
After flight or when storing, always use the inner protection sack (or AIRPack).
•
When storing or during transport make sure your glider is not exposed to
temperatures higher than 50°C.
•
Never let the glider come into contact with chemicals. Clean the glider with clean
lukewarm water only. Never clean using abrasives.
•
For long-term storage do not pack the glider too tightly. Leave the rucksack zip open
when possible to allow any moisture to evaporate.
Transport:
Some materials used in the construction of the glider are sensitive to temperature. Therefore,
the pilot should ensure that the glider is not exposed to excessive heat. For instance, do not
leave the glider in a car during hot summer days.
When packing to send by post use appropriate packing material.
Cleaning:
For cleaning just use only a soft sponge and clean water.
Do not use solvents, cleaners or abrasives.
Repairs:
Repairs must be done exclusively by the manufacturer, importer or authorised persons.
Use only original parts.
In case of questions please contact AIRDESIGN directly.
Material wear:
66