Replacing Components; Auger Motor - England's Stove Works 25-CB120 Manuel D'installation

Auger Motor
 Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down. Also, make sure the hopper is empty before attempting to
remove or replace the auger motor assembly.
 Remove the back panel of the unit, using a
motor bolts, detach the wiring harness from the auger motor.
 Locate the auger motor assembly at the rear of the stove, and begin by loosening the
1
(2) / " allen set screws on either side of the cast iron auger motor coupler.
8
 Slide the auger assembly out of the tube.
 Remove the (4) screws which hold the cast iron auger motor coupler to the auger
motor, using a
spacer plate off of the auger motor.
 Loosen the
motor output shaft, and remove the steel auger coupler, as well as the rubber
vibration dampener.
 Reinstall the parts in reverse order on the new auger motor, being careful not to
over‐tighten the bolts which hold the cast iron auger coupler to the auger motor.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
5
/ " wrench. Slide the cast iron auger motor coupler and the steel
16
1
/ " allen set screw which holds the steel auger coupler to the auger
8
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
5
/ " wrench. Before loosening any auger
16
39