Installation Complete - Oki IP-7900-26 Guide De Référence Rapide

Install the sheet cleaning part you prepared in advance
to the wiping unit.
Insert the notches on both sides of the cleaning sheet
mount between the Printer frame and the screws
installed previously. Slide the sheet cleaning part in the
direction of the arrow to insert them completely.

Installation complete

3
I N S T . S H E E T C L E A N I N G
P A R T , C L O S E C O V E R
Close the wiping cover and then the front cover.
4
C A R R I A G E M O V I N G
P L E A S E W A I T
- If the cover is opened during the sheet mount
cleaning, a warning sound is emitted and the
following message appears.
C L O S E
C O V E R
5
S H E E T M O U N T C L E A N I N G
x x : x x H A S E L A P S E D
To cancel the cleaning
Press the CANCEL
C A N C E L S H E E T M O U N T
C L E A N I N G ?
Press the key to confirm cancellation.
Cleaning ends automatically after 8 hours.
Depending on the amount of dirt, the nozzle
surfaces may be cleaned after only 2 or 4 hours.
Sheet mount cleaning may be cancelled at any time
if needed.
- If the cover is opened when the sheet mount
cleaning, a warning sound is emitted and the
following message appears.
C L O S E
C O V E R
6
C A R R I A G E M O V I N G
P L E A S E W A I T
The buzzer sounds to indicate the end of sheet mount
cleaning.
7
C L E A N I N G C O M P L E T E
P R E S S O K B U T T O N
Press the key.
- Open the wiping cover to go directly to step 10.
8
O P E N C O V E R , I N S T A L L
S H E E T C L E A N I N G P A R T
Open the front cover and then the wiping cover.
9
R E M O V E S H E E T C L E A N I N G
P A R T , C L O S E C O V E R
Remove the sheet cleaning part. Close the
wiping cover and then the front cover.
10
C A R R I A G E M O V I N G
P L E A S E W A I T
11
# S H E E T M O U N T C L E A N I N G
>
key.
39