Oki IP-7900-26 Guide De Référence Rapide page 8

5
Attach the scroller by fitting it with the roll
groove of the printer.
Scroller
Roll groove
- To set the scroller alone:
Use a recommended dolly.
Recommended dolly
Scroller
6
Remove the protection bar and open the front
cover.
7
Move the media edge guards to each side so
that they are not under the media.
Media edge guards
Printer rear (supply side)
Front cover
Protection bar
8
Rotate the pressure control knob in the arrow
direction to raise the pressure roller.
Takeup side
Pressure control knobs
9
Insert the media end into the paper feeder
while smoothing out the media by hand to
prevent wrinkles.
Paper feeder
If it is hard to insert the media end into the paper
feeder due to a curl of the media, interpose an interleaf
and insert the media end under the interleaf as shown
in the figure below.
- Up curl
10
Feed the media until the media end almost
reaches the floor.
In this state, smooth out the media toward the both
sides on the platen to make the media center tense.
Note
- If the media is set with a distortion or wrinkles, this may cause a
media jam or skew.
Supply side
or
Printer rear
- Down curl
Platen
7