Media Installation And Removal; Roll Media Installation Procedure - Oki IP-7900-26 Guide De Référence Rapide

Media installation and removal

Roll media installation procedure

1
Put the media on the table.
If you want to use a dolly, contact us. We have a
recommend product.
2
Adjust the roll spacer position according to the
media width.
Roll spacer
(1) Remove the two screws and move the roll spacer to the
center of the media. There are three screwing positions.
- The roll spacer prevents the paper tube from bending
at the center due to the media weight.
3
Insert the scroller into the paper tube,
determine the distance between the media
edge and the flange, and then secure the main
scroller.
Flange
Attach the paper setting gauge's flange side to
the flange's spoke side.
Paper setteng gauge
6 6
Do not move this roll spacer.
Scroller
Media
Handle
(1) Check the media winding direction, and then insert the
scroller into the paper tube.
Outer take-up Inner take-up
(2) Determine the distance between the media edge and the
flange with the paper setting gauge.
(3) Rotate the handle clockwise as far as it will go, and then
secure the scroller at the point.
4
Attach the flange spacer and the flange stopper
with the flange stopper matching with the claw
of the flange spacer.
Knob
(1) The flange spacer has teeth. Push it as far as it will go.
(2) Match the flange stopper with the claw of the flange
spacer, and then tighten the knob to secure the
flange spacer and the flange stopper.
Flange spacer
Flange stopper