Panasonic AW-PH400E Mode D'emploi page 23

Installation
(Be sure to ask your dealer to install the unit.)
w Attaching the wire
[Convertible Camera (AW-E350/E650/E655/E750/E860/HE870)]
A drop-prevention wire is provided with the unit.
Follow the instructions below to use it to couple the camera to the pan-tilt head.
p When attaching the wire, be absolutely sure to use a Phillips-head screwdriver to tighten the 2 mounting screws
Notes
securely.
8.5 mm
p Tighten up the mounting screw at the
torque levels specified in the table on
the right, and then check that there is
no play.
When mounting the cameras with fan
(AW-E655, AW-E750, AW-E860, AW-HE870)
Use the mounting screw for wire (M4 M 8 mm with flat
washer and spring washer) to attach one end of the wire
to the pan-tilt head's arm.
Attach one end of the wire (use the 6.5 mm hole in the
mounting fitting) to the threaded hole for mounting the
camera using the mounting screw for wire (inch thread:
1/4-20UNC), flat washer and spring washer.
For a stand-alone installation
p Camera: AW-E655, AW-E750, AW-E860, AW-HE870
Mounting screw for wire
Drop-prevention
(inch thread: 1/4-20UNC),
wire
flat washer and spring
washer
[provided with camera]
Mounting screw for wire
(M4 M 8 mm) with flat washer and spring
washer [provided with pan-tilt head]
p Camera: AW-E350, AW-E650
Mounting screw for
wire
(M4 M 8 mm) with flat
washer and spring
washer [provided with
pan-tilt head]
Drop-prevention wire (approx. 200 mm long)
4.2 mm
1.2 mm
Attaching the wire
Mounting screws (Inch thread)
Mounting screws (M4)
Arm
Mounting screw
for wire
(M4 M 8 mm) with
flat washer and
spring washer
[provided with
camera]
22 (E)
6.5 mm
4.2 mm
Hole
diameter
6.5 mm
4.2 mm
When mounting the cameras without fan
(AW-E350, AW-E650)
Use the mounting screw for wire (M4 M 8 mm with flat
washer and spring washer) to attach one end of the wire
to the pan-tilt head's arm.
Attach one end of the wire (use the 4.2 mm hole in
the mounting fitting) to the threaded hole on top of the
camera using the mounting screw for wire (M4 M 8 mm
with flat washer and spring washer).
For installation on the ceiling
p Camera: AW-E655, AW-E750, AW-E860, AW-HE870
Mounting screw for wire
(M4 M 8 mm) with flat
washer and spring washer
[provided with pan-tilt head]
p Camera: AW-E350, AW-E650
Indoor Pan/Tilt Head AW-PH400
Mounting fitting
11 mm
Clamping torque
2.0 N m (20 kgf cm)
• •
1.5 N m (15 kgf cm)
• •
Mounting screw for wire
(inch thread: 1/4-20UNC), flat washer
and spring washer
[provided with camera]
Mounting screw for wire
(M4 M 8 mm) with flat washer and spring
washer [provided with camera]
Mounting screw for wire
(M4 M 8 mm) with flat washer and
spring washer
[provided with pan-tilt head]