Wpan-Tilt Head Mounting Conditions; Parts To Be Provided By The Customer For Installation - Panasonic AW-PH400E Mode D'emploi

Installation
(Be sure to ask your dealer to install the unit.)
w Pan-tilt head mounting conditions
Pan-tilt
Mounting
head mass
specifications
(weight)
Stand-alone
installation or
Approx. 10 kg
installation on the
celling
Mounting the pan-tilt head
Recommended screws No. of screws
Hexagon head bolts (M6) 4 pcs
w Parts to be provided by the customer for installation
When installing the pan-tilt head, check the "Pan-tilt head mounting conditions" described above, and be sure to follow the
instructions below.
A hole for the drop prevention underneath support plate is provided on the bottom of the pan-tilt head separately from the holes
used to mount the pan-tilt head.
M8 hole (for mounting the
underneath support plate)
Holes for
mounting the
pan-tilt head
(4 locations)
Drop prevention
underneath support
plate
Check the positions and dimensions of the mounting holes above, and check
which is the AC inlet side. Then decide in which direction the pan-tilt head is to
be mounted, and fashion the anchors or provide the hangers.
Provide the following items to install the pan-tilt head and underneath support plate.
Embedded anchors (M6 size): C4 (for the pan-tilt head)
(M8 size): C1 (for the underneath support plate)
p For the installation positions and dimensions of the anchors, refer to the drawing on page 8.
Hexagon head bolts or nuts (M6: 4 pcs each, M8: 1 pc each)
Thickness of pan-tilt head area
Thickness of pan-tilt head area
Thickness of underneath support plate 2 mm
p When using bolts to install the pan-tilt head and underneath support plate, decide on their respective lengths after factoring
in the dimensions given above.
Flat washers, spring washers (M6: 4 pcs each, M8: 1 pc each)
Camera Camera
Compatible
mass anti-drop
cameras
(weight) measures
Convertible
camera series
AW-E350
AW-E650 Approx.
AW-E655 1.2 kg max.
Wire provided
AW-E750
used for
AW-E860
mounting
AW-HE870
Multi purpose
camera series Approx.
AK-HC1500G 1.5 kg
AK-HC1800G
Mounting the plate
Recommended screw
Hexagon head bolt (M8)
47 mm (thicker area) : C3
5 mm (thinner area) : C1
16 (E)
Lens mass
Compatible
lenses
(weight)
AW-LZ16MD55P
Approx. 1.3 kg
AW-LZ16MD73P
AW-LZ17MD9AG
HA21 series
HA22 series Approx. 3.2 kg
HJ17e series
HJ21e series
Note:
Bear in mind that mass (weight) will increase over the
No. of screw
values listed above when a prompter or other device has
1 pc
been mounted.
<Positions and dimensions of the mounting holes>
AC inlet side of pan-tilt head
: C1
Indoor Pan/Tilt Head AW-PH400
Total mass
Cable mass
(weight)
(weight)
Approx. 13 kg
max.
Approx. 0.3 kg
Approx. 15 kg
max.
4-M6 holes (for mounting the
pan-tilt head)
M8 hole (for mounting
85 mm
the underneath support
plate)