Specifications; Supply Voltage - Panasonic AW-PH400E Mode D'emploi

Indoor Pan/Tilt Head AW-PH400

Specifications

Supply voltage:

Power consumption: 145 W
indicates safety information.
Genlock input:
Prompter input
(PROMPTER IN):
Prompter output
(PROMPTER OUT):
Camera video output
VIDEO:
Y:
Pr/C:
Pb:
SDI:
Camera, pan-tilt head control:
RP/IP
Functions/performance:
Ambient operating temperature: 0 °C to +45 °C
Storage temperature:
Ambient operating humidity:
Dimensions (W V H V D):
Mass (weight):
Finish:
Mass (weight) and Dimensions indicated above are approximate.
Specifications are subject to change without notice.
AC 220 to 240 V, 50/60 Hz
BNC
Black burst or composite video signal
BNC
Through output to PROMPTER connector
D-SUB 15-pin
BNC, 75-ohm output
BNC, 75-ohm output
BNC, 75-ohm output
BNC, 75-ohm output
BNC
RJ45, RS-485, pan-tilt head control signal output
Connecting cable: 10BASE-T straight cable (equivalent to UTP category 5),
max. 500 meters
Maximum load: 8 kg
p In the event that the drop-prevention wire provided with the pan-tilt head is used to prevent
dropping, the maximum load when the pan-tilt head is used in combination with the
camera and lens is 5 kg or less. If the load exerted by the units to be installed exceeds
5 kg, measures to sufficiently withstand this load must be taken to prevent the units from
dropping.
Tilt range: 300 ° (approx. ±150 °)
The tilt range is limited to 190 ° by the initial setting of the pan/tilt control panel
(AW-RP400). To move beyond 190 °, change the AW-RP400 setting.
The tilt range is subject to restrictions depending on the cable and lens of camera to be
mounted on pan-tilt head.
Pan range: 400 ° (approx. ±200 °)
Maximum operating speed: 90 °/s
(Maximum operating speed with prompter mounted: 30 °/s)
Repeatability: ±30 "
Noise level: Less than NC30 (at less than 30 °/s)
–20 °C to +60 °C
30 % to 90 % (no condensation)
315 M 534 M 188 mm (excluding protrusions)
Approx. 10.2 kg
AV ivory paint (colour resembling Munsell 7.9Y6.8/0.8)
29 (E)