Panasonic AW-PH400E Mode D'emploi page 21

Installation
(Be sure to ask your dealer to install the unit.)
<When using anchors with an internal thread>
For a stand-alone installation
Hexagon head bolt (M6)
(short bolt)
Hexagon head bolt (M6)
(long bolt)
Spring washer
Flat washer
Secure the underneath support
plate by tightening bolt.
p Use a torque wrench whose torque can be specified
Notes
to tighten the hexagon head bolts at the torque levels
listed in the table on the right.
After tightening the bolts, check for play.
p When installing the pan-tilt head, do not forcibly turn the "rotary head" or "rotary arm" manually. Doing so may
result in malfunctioning.
For installation on the ceiling
The anchors must always
be installed.
The anchors must always
be installed.
Installing the
pan-tilt head
Hexagon head bolts (M6)
Hexagon head bolt (M8)
20 (E)
Indoor Pan/Tilt Head AW-PH400
Secure the underneath
support plate by
tightening bolt.
Clamping torque
5.0 N m (50 kgf•cm)
•
12.0 N m (120 kgf•cm)
•