Panasonic AW-PH400E Mode D'emploi page 10

Indoor Pan/Tilt Head AW-PH400
Parts and their function




Rotary head connector panel
Rotary head
This rotates in the horizontal direction.
Pedestal
POWER ON/OFF switch
When this is set to ON, the unit's power is turned on;
when it is set to OFF, it is turned off.
AC inlet [AC IN] (AC 3-point inlet)
Connect the accessory AC power cable to this inlet.
Camera mounting base mounting screws
M5 M 22 mm hexagon socket head screws, M5 flat
washers (3 of each provided as accessories)
These parts are used to secure the camera mounting
base to the rotary arm.
(See page 12)
Tally lamp (accessory)
This is lit up red by the selected signals.
Rotary arm mounting screws
M5 M 22 mm hexagon socket head screws, M5 flat
washers (4 of each provided as accessories)
These parts are used to secure the rotary arm to the
rotary head.
(See page 12)
Rotary arm
This rotates in the vertical direction.
 Camera mounting base
Mount the convertible camera on this base.
 Pan-tilt head mounting holes
These 4 holes are used when installing the pan-tilt head.
(for hexagon head bolts C4)
 Underneath support plate
In order to prevent the pan-tilt head unit from falling, use
the holes (8.5 mm, one location) in the underneath
support plate to anchor the plate in a different location
from the 4 places where the pan-tilt head is anchored.



 PROMPTER connector
The prompter is connected to this connector.
The maximum current which can be supplied from the DC
12 V OUT socket is 2 A.
When the prompter is connected, the pan-tilt head's
speed is reduced to about one-third.
When the prompter is used, be absolutely sure to
short-circuit the DETECT terminal (Pin No.14) and the
GND terminal (Pin No.15).
Note
Pin layout as seen facing the
9 (E)
Pedestal connector panel
p Consult your dealer when a prompter is to
be installed since it will be necessary for
the balance between the mounting fixture
and overall weight and other aspects to be
checked.


prompter connector
Pin No. Signal Name
1 – – –
9 – – –
2 PROMPTER VIDEO
10 PROMPTER VIDEO GND
3 – – –
11 – – –
4 DC 12V OUT
12 – – –
5 GND
13 – – –
6 – – –
14 DETECT
7 – – –
15 GND
8 – – –
!
#
"
$
%