Commissioning; Inserting The Rechargeable Battery; Charging Of Rechargeable Battery - VOLTCRAFT BS-1500T Notice D'emploi

Appareil de base – endoscope
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8. COMMISSIONING

a) Inserting the rechargeable battery
If the LiPo rechargeable battery is enclosed separately, you need to insert it first before you can use the device. If the
rechargeable battery is already inserted, you can skip this step for initial commissioning and continue with item b).
• First, open the battery lid of the endoscope basic device. It is attached on the rear in the lower part of the housing.
• For this, push the lever towards the battery lid and then take out the lid.
• Take the LiPo rechargeable battery and connect the plug of the rechargeable battery to the socket of the endo-
scope basic device. Always ensure correct polarity.
• Carefully push the cable into the opening until the plug disappears.
• Now insert the rechargeable battery in the compartment.
• Last, close the battery compartment lid again. For this, insert the little guide at the bottom into the intended slot
and push the lid closed until it latches.
• The rechargeable batteries are now inserted.
If you want to replace the LiPo rechargeable battery, take out the old rechargeable battery carefully before
you insert the new one.
Pull the connection cable through the opening until the plug is exposed and disconnect the plug connection.
Use only the genuine rechargeable battery.
b) Charging of rechargeable battery
Please also observe that the ambience temperature is not less than 0 °C or more than +40 °C while
charging. This may damage the product and the rechargeable battery.
Proceed as follows to charge the rechargeable battery.
• Pull out the rubber seal on the right side of the product and fold it to the side.
• Connect the output of the plug-in mains unit to the input socket C3 of the endoscope basic device.
• Plug the mains unit into a mains socket.
• Charging starts automatically.
The product is ready for operation even during the charging process.
If you switch on the device while it is being charged (see chapter 8 e)), a charging display D5 appears at the
lower right of the display. Once it shows 4 bars, the rechargeable battery is fully charged.
33

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1340787

Table des Matières