Swingline STACK-AND-SHRED600X Mode D'emploi page 9

1. initial setup
The shredder is designed to automatically lubricate the cutting mechanism as required to ensure
the product continues to work to its maximum performance and to extend the product life. Please
follow the operation instruction before turning on the shredder for the first time. The 60ml bottle of
oil* is sufficient to allow the shredder to start for the first time and to operate continuously for
about one hours shredding before the reservoir will need refilling. When the 'Oil Refill' indicator is
illuminated ( ), flip up the oil reservoir cap and refill the oil reservoir using a bottle of standard
Swingline oil (1760049)*. The automatic oiling operation (
and you will hear the distribution pump during this time. Auto-oiling operates after 15 minutes of
shredding time.
bin or loading door open safety function
As a safety precaution, if the bin or loading door is opened during shredding, the shredder will stop
and the bin full indicator will illuminate (
intelligent help
1 In the unlikely event of the shredder jamming, the Stack and Shred 600X and 600M will stop
shredding, and the jam icon will blink in orange.
2 The shredder will illuminate the FWD (
to clear the jam.
3 If the jam cannot be intelligentally cleared, the jam icon (
open the auto feed chamber to clear any jammed material.
automatic jam clearance
Intelligent Jam Clearance: In the unlikely event of the shredder jamming, the Stack and Shred 600X
and 600M will automatically reverse and forward the engine three times to clear a jam. During this
operation the Paper Jam indicator will flash (
self-cleaning cutters
After emptying and replacing a full bin, the shredder will run in forward for 4 seconds, stop for
2 seconds and then reverse for 4 seconds to clear away any remaining paper from the cutter
mechanism. This unique 'self-cleaning' mechanism is additional jam prevention technology
from Swingline.
lubrication of the shredder
Only use oil sheets to lubricate. ACCO Brands accepts no liability for product performance or
safety when other types of lubricants are used on any part(s) of this machine. Insert the oil sheet
into the manual feed slot and NOT in the auto-feed chamber. Using an oil sheet in the auto-feed
chamber will contaminate the feed rollers preventing the auto-feed mechanism shredding. Follow
the maintenance instructions if the rollers become contaminated. Do not directly oil the shredder.
* ACCO Brands accepts no liability for product performance or safety when other types or brands of lubricants are used on any
part(s) of this machine.
) last approximately two seconds
).
) and REV ( ) buttons in the sequence necessary
) will illuminate in red. At this point
).
S T A CK -AND-SHRED 600X&600M
English
9
™
SHREDDER S