LG G900UM Guide De Démarrage Rapide page 26

Safety Guidelines
heat from the tissues that absorb energy from the wireless
device and is set well below levels known to have effects.
Manufacturers of wireless devices must report the RF
exposure level for each model of device to the FCC/ISEDC.
The FCC website (http://www.fcc.gov/oet/rfsafety) gives
directions for locating the FCC identification number on your
device so you can find your device's RF exposure level in
the online listing.
8. What has the FDA done to measure the radiofrequency
energy coming from wireless devices?
The Institute of Electrical and Electronic Engineers (IEEE)
is developing a technical standard for measuring the
radiofrequency energy (RF) exposure from wireless devices
and other wireless handsets with the participation and
leadership of FDA scientists and engineers. The standard,
'Recommended Practice for Determining the Spatial-
Peak Specific Absorption Rate (SAR) in the Human Body
Due to Wireless Communications Devices: Experimental
Techniques, ' sets forth the first consistent test methodology
for measuring the rate at which RF is deposited in the
heads of wireless device users. The test method uses a
tissue simulating model of the human head. Standardized
SAR test methodology is expected to greatly improve the
consistency of measurements made at different laboratories
on the same device. SAR is the measurement of the
amount of energy absorbed in tissue, either by the whole
body or a small part of the body. It is measured in watts/
kg (or milliwatts/g) of matter. This measurement is used to
determine whether a wireless device complies with safety
guidelines.
9. What steps can I take to reduce my exposure to
radiofrequency energy from my wireless device?
If there is a risk from these products - and at this point we
do not know that there is - it is probably very small. But if
you are concerned about avoiding even potential risks, you
can take a few simple steps to minimize your exposure to
24