Options; Acoustic Signals; Save Energy - Atag VA63111ST Notice D'utilisation

OPTIONS

Activate or deactivate the options be-
fore the start of a programme. You
cannot activate or deactivate the op-
tions while a programme operates.
If one or more options are set, make
sure that the related indicators are on
before the programme starts.

SAVE ENERGY

This option decreases the temperature in
the last rinse phase.
The use of this option decreases the energy
consumption (up to 25%) and the pro-
gramme duration.
The dishes can be wet at the end of the
programme.
How to activate the SAVE ENERGY
option
1.
Press . The related indicator
comes on. In the display you can see
the update of the programme duration.
• If the option is not applicable to the
programme, the related indicator
flashes quickly 3 times and then goes
off.
Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the use of rinse aid
and salt. The related indicators stay off.
The programme duration can increase.
How to activate the Multitab option
1. Press
, the related indicator comes
on.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Set the water softener to the highest
level.
2. Make sure that the salt container and
the rinse aid dispenser are full.
3. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
4. Adjust the water softener to the water
hardness in your area.
5. Adjust the released quantity of rinse aid.

Acoustic signals

The acoustic signals operate when the ap-
pliance has a malfunction, when the adjust-
ment of the level of the water softener oc-
curs and when the programme is comple-
ted.
By default, the acoustic signals are on, but
it is possible to deactivate them.
How to deactivate the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'Setting and
starting a programme'.
2. Press and hold, at the same time, but-
ton and button
dicators of buttons
and start to flash.
3. Press button
• The indicators of buttons
and go off.
• The indicator of button
ues to flash.
• The display shows the current setting.
Acoustic signal on.
Acoustic signal off.
4. Press button
ting.
5. Press the on/off button to deactivate the
appliance and to confirm the setting.
How to set the colour of the
TimeBeam
It is possible to change the colour of the
TimeBeam to match the colour of the kitch-
en floor. There are 9 different colours availa-
ble.
It is also possible to deactivate the Time-
Beam.
1. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'Setting and
starting a programme'.
2. Press and hold, at the same time, but-
ton and button
21
until the in-
, ,
.
,
contin-
to change the set-
until the in-