Max HN120 Manuel D'utilisation Et D'entretien page 14

Hammer
Punch
Regular screwdriver
Feed pawl retainer
This part comes into contact to
HOW TO REMOVE JAMMING OF PINS/NAILS
WARNING:
When removing jamming of pins (or nails), be sure to lock the trigger prior to
disconnecting the air hose.
PROCEDURE
q Lock the trigger and disconnect the air hose.
w Remove the pins (or nails) out of the magazine.
e Open the door, put a punch through the ejection port and hit it with a hammer.
r Remove the pins (or nails) jamming inside the nose, using the punch or a regular
screwdriver.
t Set the pins (or nails) properly onto the feed pawl again and close the door.
TROUBLESHOOTING
● The Machine is not activated even if it is operated correctly.
When the pins (or nails) are not fed properly, a locking mechanism works to
deactivate the Machine. (Unless the feed pawl is completely OUT, it comes into
contact with a feed pawl retainer, disabling pin/nail driving work.)
If the feed pawl is not located appropriately, remove the pins (or nails) and set
them again.
● No pin (or nail) is driven even if the Machine is operated correctly.
If the Machine is activated, but no pin (or nail) is actually driven, check the
following:
q Check whether or not the pins (or nails) have been set properly onto the feed
pawl.
w Check whether or not the pins (or nails) have come off the Plasticsheet.
※ If this is the case, cut off the empty Plasticsheet and set the pins (or nails)
again.
e Check whether or not the feed pawl and feed piston are being activated.
※ If not activated, apply 5 to 6 oil drips from the air plug.
14