Model Identification - Max HN120 Manuel D'utilisation Et D'entretien

Door

MODEL IDENTIFICATION

SEQUENTIAL TRIP
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger.
This makes accurate fastener placement easier, for instance on framing, toe nailing and crating
applications. The Sequential Trip allows exact fastener location without the possibility of driving a
second fastener on recoil, as described under ･Contact Trip･.
The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a
fastener if the tool is contacted against the work-or anything else-while the operator is holding the
trigger pulled.
SINGLE FIRE OPERATION (SEQUENTIAL TRIP)
For single fire operation, depress the contact arm against the work surface and pull the trigger. Tool
can not fire a second nail until the trigger is released and tool can cycle.
2
1
Trigger lock dial
i Push the door to close it.
CAUTION:
Push the door firmly until the door lever has clicked.
o Close the magazine cap.
!0 Connect the air chuck to the air plug. You are now ready to drive the pins (or
nails).
SEQUENTIAL TRIP
Identified by ORANGE TRIGGER.
PROCEDURE
q Depress the contact arm.
w Pull the trigger.
TRIGGER LOCK MECHANISM
The tool is equipped with a trigger lock mechanism. Push and rotate the trigger
LOCK to the trigger UNLOCK position before driving nails.
Trigger
12