Homelink; To Erase The Memory - Chamberlain B503C Manuel Du Propriétaire

Operation
Remote Control (continued)
PROGRAM USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Press and immediately release the Learn button. The Learn LED will glow steady for 30
seconds. Within 30 seconds...
3. Remote Control: Press and hold the button on the remote control that you wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keyless entry keypad. Then press and hold the ENTER button.
Release the button when the garage door opener lights blink or two clicks are heard. When replacing
the light lens cover, ensure the antenna wires are hanging straight down.
1-2
LEARN
Button
LEARN LED
To watch a video, go to tinyurl.com/lcsf6xt
®

HomeLink

If your vehicle is equipped with HomeLink, a Compatibility Bridge
certain vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.
3
PIN
TM
(not included) may be necessary for

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (Including MyQ
1. Press and hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes
are now erased. Reprogram any accessory you wish to use.
36
®
enabled accessories)