Waste Disposal And Environmental Protection; Spare Parts - IKRA IBT 25-1 Mode D'emploi

CORRECTING FAILURES OF THE ENGINE
PROBLEM
Engine does not start or starts,
but does not run further.
Engine starts, but does not run at full
power.
Engine splutters.
No power under load.
Engine does not run smoothly.
Excessive exhaust gases (smoke).

Waste disposal and environmental protection

Should your tool become unserviceable or if you no
longer require it, do not dispose of it under any circum-
stances in your normal household waste, but rather in an
environmentally friendly manner. Empty the oil and petrol
tank carefully and take the leftover fuel to a collection
point. Please (also) take the tool to a recycling centre,
where the plastic and metal parts can be separated out
and sent for recycling. You can also obtain information
on this by contacting your local authority or city council.
Warranty
For this petrol tool, the company provides the end user
- independently from the retailer's obligations resulting
from the purchasing contract - with the following war-
ranties:
The warranty period is 24 months beginning from the
hand-over of the device which has to be proved by the
original purchasing document. For commercial use and
use for rent, the warranty period is reduced to 12 months.
Wearing parts and defects caused by the use of non
fitting accessories, repair with parts that are not original
parts of the manufacturer, use of force, strokes and
breaking as well as mischievous overloading of the motor
are excluded from this warranty. Warranty replacement
does only include defective parts, not complete devices.
GB | Operating Instruction
POSSIBLE CAUSE
Wrong starting process.
Wrong setting of the carburettor.
Fouled spark plug.
Clogged fuel filter.
Wrong choke lever position.
Dirty/clogged spark grid.
Dirty/clogged air filter.
Wrong setting of the carburettor.
Wrong setting of the carburettor.
Wrong setting of the spark plug.
Wrong setting of the carburettor.
Improper fuel mixture.
Warranty repair shall exclusively be carried out by au-
thorized service partners or by the company's customer
service. In the case of any intervention of not authorized
personnel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.

Spare parts

Please contact our service department if you need acces-
sories or spare parts.
When working with this machine, do not use spare parts
other than those recommended by us. Using spare parts
not recommend by us can result in serious injuries to
persons or damage to the machine.
GB-9
CORRECTION
Refer to the instructions in these
operating instructions.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Clean/adjust or replace spark plug.
Replace the fuel filter.
Put the lever to position BETRIEB
(OPERATION).
Replace the spark grid.
Remove, clean and reassemble filter.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Clean/adjust or replace spark plug.
Have the carburettor settings adjusted by
an authorised customer service organisation.
Use the proper fuel mixture (ratio – 40:1).