Manual Tuning; Digital Aerial Manual Search; Digital Cable Manual Search; Analogue Manual Search - Salora 32LED 7115CDW Mode D'emploi

Manual Tuning

HINT: This feature can be used for direct broadcast
entry.
• Select Manual Channel Scan from the Installation
menu by using " "/" " and OK buttons. Manual
Scan options screen will be displayed.
• Select the desired
" " button. Manual search options will change
accordingly. Use " "/" " button to highlight an item
and then press " " or " " button to set an option.
You can press "MENU" button to cancel.

Digital Aerial Manual Search

In manual channel scan, the number of the multiplex
or frequency are entered manually and only that
multiplex or frequency are searched for the channels.
After selecting search type as Digital, you can enter
the multiplex or frequency number using the numeric
buttons and press OK button to search.

Digital Cable Manual Search

In cable manual scan, you can enter frequency,
modulation, symbol rate and network channel scan
options. After selecting search type as Digital Cable,
you can set the desired options and press OK button
to search.
Search Type using " " or

Analogue Manual Search

After selecting search type as analogue, you can use
" "/" " button to highlight an item and then press "
" or " " button to set an option.
Enter the channel number or frequency using the
numeric buttons. You can then press OK button
to search. When the channel is located, any new
channels that are not on the list will be stored.

Analogue Fine Tune

• Select Analogue Fine Tune from the Installation
menu by using " " or " " and OK buttons. The
analogue fine tune screen will be displayed. The
Analogue Fine Tune feature will not be available if
there are no analogue channels, digital channels
and external sources stored.
• Press OK button to proceed. Use " " or " " button
to set Fine Tune. When finished, press OK button
again.

Network Channel Scan

Select Network Channel Scan from the installation
menu by using " " or " " and OK buttons. Network
Channel Scan selection screen will be displayed.
Select Digital Aerial or Digital Cable and press
OK button to continue. The following message will
be asked. Select Yes to continue or select No to
cancel.
If you start Digital Aerial scan process, automatic
scanning will start. You can press "MENU" button
to cancel.
If you start Digital Cable scan process, the following
screen will be displayed.
English - 56 -