Detaching The Front Panel (Xav-602Bt Only) - Sony XAV-712HD Mode D'emploi

6
Select [Sony Car Audio] shown in the
display of the BLUETOOTH device.
7
If passkey* input is required on the
BLUETOOTH device, input [0000].
* Passkey may be called "passcode," "PIN code,"
"PIN number," "password," etc., depending on the
BLUETOOTH device.
8
Select this unit on the BLUETOOTH device
to establish the BLUETOOTH connection.
or lights up when the connection is made.
Note
While connecting to a BLUETOOTH device, this unit
cannot be detected by another device. To enable
detection, terminate the current connection.
Connecting with a paired BLUETOOTH
device
This chapter explains how to connect manually to
registered BLUETOOTH devices.
1
Make sure that the BLUETOOTH signals
both on this unit (page 27) and the
BLUETOOTH device are activated.
on the status bar indicates that the
BLUETOOTH signal on this unit is on.
2
Operate the BLUETOOTH device to
connect to this unit.
or appears.
When the ignition is turned to on with the
BLUETOOTH signal activated, this unit searches for
the last-connected BLUETOOTH device, and
connection is made automatically if possible.
Note
If this unit cannot detect the last-connected
BLUETOOTH device, touch [Reconnect] to search for the
last-paired device again.
If the problem is not solved, follow the pairing
procedure.
To install the microphone
To capture your voice during handsfree calling, you
need to install the microphone (supplied).
For details on how to connect the microphone, refer
to the supplied "Installation/Connections" guide.
Detaching the front panel (XAV-
602BT only)
You can detach the front panel of this unit to
prevent theft.
Caution alarm
If you turn the ignition switch to the off position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
To deactivate the caution alarm, set [Front
Panel Caution Alarm] to [OFF] (page 26).
1
Press and hold OFF for more than 2
seconds to turn off the unit.
2
Press .
3
 Lift the left side of the front panel.
 Pull it off towards you.
Note
Do not drop or put excessive pressure on the front
panel and display window.
Attaching the front panel
Engage part  of the front panel with part  of the
unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not put anything on the inner surface of the front
panel.
9
GB