Breville Juice Fountain BJE510XL/A Livret D'instructions page 22

TROUBLEShOOTING PAge heAder.....
POSSIBLE PROBLEM
Machine will not work
when turned ON
Motor appears to stall
when juicing
Excess pulp building
up the Nutri Disc™
Pulp too wet and
reduced extracted juice
Juice leaks between the
rim of the juicer cover
22
EASy SOLUTION
• The safety locking arm may not be correctly engaged in
the vertical operating position with the locking arm located
into the two grooves on either side of the juicer cover.
• Wet pulp can build up under the juicer cover if the juicing
action is too vigorous. Try slower juicing action by pushing
the food pusher down slower. Follow Disassembling and
Cleaning instructions and clean the filter bowl surround,
the juice disc and the juicer cover.
• The juicer will automatically stop operating if the motor
is stalled for more than 10 seconds. Either too much food
is being processed at one time or the pieces are not small
enough. Try trimming the food or cutting into smaller
pieces of even size and processing a smaller amount per
batch. To continue juicing, reset the juicer by pressing the
'On/Off' switch on the control panel to 'Off' then turn the
appliance back on by pressing 'On/Off' switch to 'On'.
• Hard fruits and vegetables will put excess strain onto the
motor if a low speed is selected. Please refer to the juicing
guide to determine the correct speed for the fruits and
vegetables selected for juicing.
• Stop the juicing process and follow Disassembling
Instructions. Remove the juicer cover, scrape off pulp,
reassemble and begin juicing again. Try alternating (soft
and hard) vegetable and fruit varieties.
• Try a slower juicing action.
• Remove Nutri Disc™ and thoroughly clean mesh walls
with a cleaning brush. Rinse the Nutri Disc™ under hot
water. If the fine mesh holes are blocked, soak the basket
in a solution of hot water with 10% lemon juice to unblock
the holes or wash in the dishwasher. This will remove
excess fiber build up (from fruit or vegetables) which
could be inhibiting the juice flow.
• Try a slower juicing speed and push the food pusher down
the feed chute more slowly.