Oki IP-5620 Guide De Référence Rapide page 38

6
Dip the cleaning roller in the cap cleaning
liquid.
Note
- Do not dip a cleaning roller once used for cleaning
in the cap cleaning liquid bottle.The cap cleaning
liquid will get dirty.
7
Clean on the surface of the cap by rolling the
cleaning roller.
1.
First, roll the cleaning roller on each cap,
going back and forth once.
2.
Next, roll the cleaning roller on each 30
times.
Caps may also be cleaned using the cleaning
swabs (thick) sold separately.
Note
- The cleaning roller is intended for a single use only.
Use a new cleaning roller for each cleaning.
- If the caps are still dirty after cleaning, take a new
cleaning roller and perform cleaning again.
- With the 4 color specifications, the 2 caps on the
left side do not require to be cleaned.
8
Close the cap cover and the front cover.
The carriage automatically returns to the original
position.
Note
- Do not expose the print heads for an unnecessarily
long time when taking them out of the capping unit.
The print heads may dry and cause malfunction.
- After cleaning, if print defects still occur, remove
foreign matters and ink stains on the cap with the
cleaning swab soaked with cap cleaning liquid while
checking visually.
- Be careful not to put cap cleaning liquid on parts of
the printer other than the cap.
(5) Execute the print head cleaning
[NORMAL]
Select PH.REC MENU from the operation panel and
then [NORMAL] to perform the cleaning.
(6) Execute a nozzle print
The nozzle print is performed to confirm that the
nozzles of the print head are not blocked. Before
printing each day or after cleaning the caps, run the
nozzle print to verify the print head performance.
1
Set the printer to offline. (Press
h INK
f MEDIA
2
Press key twice to display ADJUST
MENU.
h PRINTER
f ADJUST
3
Press key to display the nozzle print.
#NOZZLE PRINT
#EXECUTE>
4
Press key.
#NOZZLE PRINT
#EXECUTE>
5
Press key.
#NOZZLE PRINT
*OK ?
6
Press key.
#NOZZLE PRINT
*EXECUTING
7
When pressing key, after performing the
warm-up, the adjustment pattern shown in
the next page is printed.
key.)
MEDIA REG i
M.ADV g
SETUP i
HEATER g
37