Oki IP-5620 Guide De Référence Rapide page 29

11
Lower the pressure roller up / down lever.
After this, follow the instructions on LCD screen.
Note
To lower (press) the pressure roller, lower the pres-
sure roller up / down lever to the lowest position.
12
Open the front cover and align the media
edge guards over the both ends of the
media. Then, close the front cover.
Check that the media edge guards do not go under
the media and that thick media is not stuck between
them.
After visually confirming that the media edge guards
are properly set, press the
CHECK EDGE GUARD
*OK ?
13
Select either the roll media or the cut media
(sheet).
Either [roll] or [sheet] can be selected with
key. Here, select [roll] and press the
return to the media selection, press the
SELECT MEDIA
ROLL/SHEET:ROLL
SELECT MEDIA
ROLL/SHEET:SHEET
14
Select the type of media.
Select the type of media registered with the
keys and press the
SELECT MEDIA
MEDIA:PAPER
SELECT MEDIA
MEDIA:XXX
28
key.
key or
key. (To
key.)
and
key.
To register a new media
[NEW MEDIA ENTRY ] is displayed at the end of media
registration. Press the key to enter [MEDIA REG MENU]. The
media registration procedure is the same as the registration
from the registration menu.
Press key to return from the media registration menu to
the media type selection menu. To return to the value before
input, press the key.
SELECT MEDIA
MEDIA:PAPER
SELECT MEDIA
MEDIA:XXX
The registered media is displayed.
SELECT MEDIA
NEW MEDIA ENTRY
15
Enter the remaining length of media.
Enter the remaining length of roll media loaded to
the printer.
REMAINING MEDIA
*XXXm
16
The media set operation automatically
starts.
PREPARING MEDIA
PLEASE WAIT
- When successfully finished, the printer returns to
the online state or offline state.
- If an error occurs, an error message is displayed. Go
back to step 1 and start the procedure again.
Note
- After installing the media, check that the media
does not enter in the gap of the media cutter blade
or is not pinched by the media clip. Also make sure
the media on the platen has no curl or wrinkles.
(Enter in the registration menu.)