Pregnancy Display; Fever And High Temperature; Measurement Button Pressed Without Sensor At Point Of Measurement; Irregular Cycle - uebe cyclotest 2 plus Mode D'emploi

Frequently asked questions
Again press the large round Measurement button once briefly.
To turn the wake-up alarm back on, proceed as described above. The
unit confirms the input with a beep.

Pregnancy display

cyclotest® 2 plus is waiting for your cycle start. In this case, there are
two possibilities:
1) You have forgotten to start a new cycle on the first day of
menstruation.
2) If there is no menstruation, you may be pregnant.
Important: If within a cycle you observe inexplicable temperature re-
sponses which deviate from your previous cycles, call the cyclotest®
service hotline.
Fig. no. 26
Wake-up alarm on (more bars)
Fig. no. 27
Wake-up alarm off (fewer bars)
Fig. no. 28
EN-58
Frequently asked questions

Fever and high temperature

An atypical increase in temperature is blanked out during the cycle re-
cording. If there are not enough temperature values that can be evalu-
ated during a cycle, the fertile phase is extended. See Fig. no. 11 "H".
Measurement button pressed without sensor at point
of measurement
cyclotest® 2 plus breaks off the measurement and signals this acousti-
cally with three beeps and optically with an "E". See Fig. no. 13.

Irregular cycle

The unit displays a cycle length of 32 days in the bar chart. Counting
is continued automatically for longer cycles.
In the event of irregular cycle lengths, a longer fertile phase is
displayed.
EN-59
Fig. no. 29
You can recognise this by the flashing square
in the bar chart, by the small arrow under-
neath and by the digit at top left.