Cleaning And Maintenance - Krups XP3200 Mode D'emploi

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
English
n To clean the nozzle, place the steam nozzle in a small container filled
with water.
n Turn the dial to the
n Once the indicator light has stopped blinking, turn the dial to
the position to remove any remaining milk. Run in the steam
position for at least 30 seconds.
n Then turn the dial to the
outside of the steam nozzle with a clean cloth.
For thorough cleaning of the steam nozzle, see Section 7, "Cleaning of
the Steam Nozzle".

7. CLEANING AND MAINTENANCE

O F T H E A P P L I A N C E :
n Make sure the coffee machine is unplugged and completely cooled
down before you begin to clean it.
n The removable parts can be cleaned using a cloth and gentle
washing-up liquid and water.
n Do not immerse the coffee machine in water or any other liquid.
O F T H E F I LT E R H O L D E R H O U S I N G :
n Using a damp cloth, regularly clean the filter holder housing in order to
remove any coffee residue which may be stuck there.
n To prolong the life of the percolation head gasket seal, do not put the
filter holder back into place if the coffee machine is not to be used for
a long time.
O F T H E S T E A M N O Z Z L E :
n Regularly remove the plastic accessory of the steam nozzle (k)
(Fig. 16) and rinse it.
n To unblock the hole in the steam nozzle outlet, you may use a needle.
O F T H E D R I P T R AY :
n The drip tray must be emptied after each time the appliance is used.
n If multiple espressos are prepared one after another, it should be
emptied from time to time (every 6 cups of espressos approximately)
(fig.17).
14
position.
O
(i1) (fig. 15) position and wipe the