Milk Frothing Function - Krups XP3200 Mode D'emploi

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
English
W I T H S O F T P O D S :
Besides coffee, this machine can also work with espresso ground cof-
fee pods.
n Place the espresso pod in the filter (c1).
n Be sure to place all the paper inside the filter holder, to avoid
leaks and get a good result in the cup.
n Insert and turn the filter holder to the right
n Then follow the procedure for preparing an espresso with espresso
ground coffee.

6. MILK FROTHING FUNCTION

n Steam can be used to froth milk by using the steam wand with
frothing nozzle (for example to make a cappuccino or latte).
n As the machine produces steam, the pump will make a thumping
sounds. This sound is normal and is an indication that the machine is
operating properly.
n After using the steam function, the machine purges
automatically and cools down by pumping cold water through the
heating system. During the purging cycles of cold water, the excess
steam in the heating system is released with hot water into the drip
tray.
n The steam and noise that accompany this phase is important for
cooling the machine.
Caution: During and after using the steam wand, the
metal parts of the steam wand can become very hot.
Take care when handling the steam wand to avoid injury.
S Y S T E M AT I C P U R G E O F T H E S T E A M C I R C U I T :
Each time before you make frothy milk, you must purge the steam
circuit:
n Place an empty container under the steam nozzle (k).
n Turn the Steam function selector switch (i) to the
(fig. 12). The Steam light (i4) comes on.
n Turn the Steam function selector switch (i) to the
(fig. 13) in order to purge the circuit.
12
(fig.7).
position (i2)
position (i3)