Disposing Of Your Machine - Krups XP3200 Mode D'emploi

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
Problems
Your espresso
tastes bad.
The machine
does not work
The steam
wand does
not froth the
milk.

10. DISPOSING OF YOUR MACHINE

Environmental protection first!


Possible causes
After descaling, the
rinsing was not
performed properly.
The pump could not
be primed due to
lack of water.
The water tank is
not properly
positioned.
The steam nozzle is
clogged or needs to
be descaled.
The milk is not cold
or not fresh enough.
The shape of the
container is not
appropriate for
frothing.
Your machine contains a lot of recoverable or recyclable
material.
When disposing of your machine, consult your local
waste collection agency to determine the proper method
of recycling and/or disposal.
Solutions
Rinse the machine carefully after
descaling (see Section 8).
Fill the water tank and re-prime the
pump (see Section 4). Always check
before starting a cycle to see that
there is sufficient water in the water
tank. Avoid allowing the tank to run
dry when operating the machine.
Replace the water tank in the
proper position.
Carefully clean (see Section 7) or
descale the steam wand (see
Section 8).
Use fresh, cold milk in a cold
container. Pasteurised or UHT milk
is recommended. Whole, lowfat, or
skim milk can all be frothed. Try
using a different brand of milk.
Use a small pitcher-shaped
container with a small diameter for
best results. Also, chilling the
container before adding the milk will
improve results.
English
19