Krups XP3200 Mode D'emploi page 15

IFU_KR_COFFEE_MAKER_XP3200_ 8000828507-01_Mise en page 1 13/09/10 16:38 Page1
English
n Press the "on/off" button to turn the machine on, and then immediately
turn the dial to the
n Let the mixture run through the nozzle until steam appears.
n Then turn the dial back to the
n Place the container under the filter holder.
n Once the indicator link stops blinking, turn the dial to the
(fig. 5)and run half of the remaining water through.
n Turn the machine by pressing the "on/off" button and leave the dial
at the
and replace under the filter holder.
n After 15 minutes, turn the machine back on.
n Let the rest of the water run through until the water tank is empty.
n Then turn the dial to the
R I N S I N G
IMPORTANT!
After descaling, rinse 2-3 times with clean water as des-
cribed in Section 4 "BEFORE FIRST USE". Then rinse
the steam nozzle by following the instructions below:
n Fill the water tank with clean water. Then place a container under the
steam nozzle.
n Press the "on/off" button to turn the machine on, and then
immediately turn the dial to the
stopping at the
n Let the water run through the nozzle until steam appears.
n Turn the dial back to the
The machine is now descaled and ready to be used again.
16
position, without stopping at the
(h2) position. Empty the container under the filter holder
(h1). position.
(i2)position.
O
(i1) (fig. 15) position.
O
(i1) (fig. 15) position.
(i3) (fig. 13)position, without
(i2))position.
(h2)