Air Shutter-Broil Burner; When All Hookups Are Complete; Model And Serial Number Location; Before You Call For Service - Electrolux EW30GS65G Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
flame size. Turn clockwise to decrease flame size. Adjust
flame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing the flame.
Flame should be as small as possible without going
6. Operation of Oven Burners and Oven
Adjustments
10.6.1 Electric Ignition Burners
Lower
Oven Baffle
(removable)
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks, and range has been connected to
electric power.
The oven burner is equipped with an electric control
system as well as an electric oven burner igniter. If your
model is equipped with a waist-high broil burner igniter,
it will also have an electric burner igniter. These control
systems require no adjustment. When the oven is set to
operate, current will flow to the igniter. It will "glow"
similar to a light bulb. When the igniter has reached a
temperature sufficient to ignite gas, the electrically
controlled oven valve will open and flame will appear at
the oven burner. There is a time lapse from 30 to 60
seconds after thermostat is turned ON before the flame
appears at the oven burner. When the oven reaches the
display setting, the glowing igniter will go off. The burner
flame will go "out" in 20 to 30 seconds after igniter goes
"OFF". To maintain any given oven temperature, this
cycle will continue as long as the display is set to operate.
After removing all packing materials and literature from
the oven:
a) Set the oven to BAKE at 300°F. See Use & Care Guide
for operating instructions.
b) Within 60 seconds the oven burner should ignite.
Check for proper flame, and allow the burner to cycle
once. Reset controls to off.
c) If your model is equipped with a high-waist broiler, set
3
Lock Screw
2
Air Shutter
Figure 13
(Models with Sealed Top Burners)
Waist-High
Burner
Air Shutter
Lower Oven Bottom
(removable)
Air Shutter
Oven Burner Tube
Orifice Hood
1
oven to broil. See Use & Care Guide for operating
instructions.
d) Within 60 seconds the broil burner should ignite.
Check for proper flame. Reset controls to off.
10.6.2 Air Shutter-Oven Burner
The approximate oven burner flame length is 1 inch
(distinct inner cone of blue flame).
To determine if the oven burner flame is proper, remove
the oven bottom and burner baffle and set the oven to
bake at 300°F.
To remove the oven bottom, remove oven hold down
screws at rear of oven bottom. Pull up at rear, disengage
front of oven bottom from oven front frame, and pull the
oven bottom out of the oven. Remove burner baffle so
that burner flame can be observed.
If the flame is yellow, increase air shutter opening size (see
"2" in Figure 13). If the entire flame is blue, reduce the air
shutter opening size.
To adjust frame loosen lock screw (see "3" in Figure 13),
reposition air shutter, and tighten lock screw. Replace
oven bottom.

10.6.3 Air Shutter-Broil Burner

The approximate flame length of the burner is 1 inch
(distinct inner cone of blue flame). To determine if the broil
burner flame is proper, set the oven to broil. If flame is
yellow, increase air shutter opening size (see "2" in Figure
13 ). If the entire flame is blue, reduce the air shutter
opening size. To adjust, loosen lock screw (see "3" in Figure
13), reposition air shutter, and tighten lock screw.

When All Hookups are Complete

Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the range is unobstructed.

Model and Serial Number Location

The serial plate is located on the oven front frame
behind the oven door (some models) or on the drawer
side frame (some models).
When ordering parts for or making inquiries about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your range.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the range was
adjusted for when it left the factory.

Before You Call for Service

Read the Before You Call Checklist and operating
instructions in your Use and Care Guide. It may save you
time and expense. The list includes common
occurrences that are not the result of defective
workmanship or materials in this appliance.
10
Refer to your Use & Care Guide for service phone
numbers.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ew30gs65gsEw30gs65gbEw30gs65gw

Table des Matières