Standard Conditions - ESAB ESP-150 Manuel D'instruction

SECTION 4
Material
Type-Thickness
Current
in.(mm)
(Amps)
CS-1/8 (3.2)
CS-3/16 (4.7)
CS-1/4 (6.35)
CS-5/16 (8)
CS-3/8 (9.5)
CS-1/2 (12.7)
CS-5/8 (15.9)
CS-3/4 (19)
CS-1 (25.4)
CS-1/16 (1.6)
CS-1/8 (3.2)
CS-1/4 (6.3)
CS-5/16 (8)
CS-3/8 (9.5)
CS-1/2 (12.7)
CS-5/8 (15.9)
CS-3/4 (19)
CS-1 (25.4)
CS-1-1/8 (28.6)
CS-1-1/4 (31.7)
CS-1-3/8 (34.9)
CS-1-1/2 (38)
CS-1-3/4 (44.5)
CS-2 (50.8)

STANDARD CONDITIONS

The cutting speeds and conditions in the following tables were selected to give
the best quality with a particular gas combination at a specific current.
Consumables - Refer to PT-26 Torch manual for recommended parts for these
conditions. Use of parts in combinations and applications other than as described
herein can result in damage to the torch or poor performance.
Gas and Current Selection- Refer to Page 28 and the following tables to chose
the most appropriate conditions for your application.
Table 2. PT-26 Carbon Steel Cutting Data
Travel
Speed
ipm(M/m)
50 195 (4.95)
150 (3.8)
100 (2.58)
75 (1.9)
50 (1.27)
25 (.63)
12 (.3)
6 (.15)
2 (.05)
150 175 (4.45)
155 (3.94)
137 (3.48)
125 (3.17)
87 (2.2)
76 (1.93)
62 (1.57)
50 (1.27)
30 (.76)
25 (.63)
20 (.5)
15 (.38)
13 (.33)
6 (.15)
4 (.10)
Cutting
Start Gas
Height
Type/Pressure
in.(mm)
psi(bar)
5/16 (8) Air - 30 (2.1)
5/16 (8) Air - 30 (2.1)
148
OPERATION
Shield Gas
Plasma Gas
Type/Pressure
Type/Pressure
psi(bar)
psi(bar)
Air - 60 (4.14) Air - 50 (3.45)
Air - 60 (4.14) Air - 50 (3.45)