Installation Instruction - Caso Germany EMCG 32 Mode D'emploi Original

• The electrical safety of the device is only guaranteed if the device is
connected to a properly installed protective conductor system.
Operations using an electrical outlet without a protective conductor are
prohibited. If in doubt, have the house installation checked over by a
qualified electrician.
The manufacturer cannot be made responsible for damages that are
caused by a missing or damaged protective conductor.
• Adapters, multi-way strips and extension leads must not be used.
Overloading can lead to fire.
• If the plug is no longer accessible following installation an all-pole
isolating switch must be present on the installation side with a contact
gap of at least 3mm.
• In accordance with the appropriate regulations, the socket must be
installed and the connecting cable must be replaced only by a qualified
electrician.

11.5.3 Installation instruction

• Please observe this special installation instructions.
• The appliance can be installed inside a 60cm wide wall-mounted
cupboard (at least 55cm deep and 85cm off the floor).
• The built-in cabinet shall not have a rear wall behind the appliance.
• Do not cover ventilation slots and air intake points.
caso EMCG 32
Do not trap or kink the power cord.
Make sure that the oven is installed in
the center of the cabinet.
30 mm free space is needed above the
device top surface
Open the door; fix the oven to the
cabinet with screw at the installation
hole. Then fix the trim-kit plastic cover
(1) on the screw (2) in the installation
hole (3).
Please note
► Install or locate this oven only in
accordance with the installation
instructions provided.
► The outside surfaces of the cabinet
may get hot.
59