Dubbing From Tape To Tape - Sharp CD-BA3100 Mode D'emploi

Dubbing from Tape to Tape

You can record from TAPE 1 to TAPE 2.
For recording, use only normal tapes. Do not use metal or CrO
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette into the TAPE 1 cassette compart-
ment. Insert a blank tape into the TAPE 2 cassette compartment.
It is recommended that the recording tape is the same length as the master tape.
3
Press the TAPE (1 V 2) button until "TAPE 1" appears on the
display.
4
Press the REC PAUSE ( 6 I6) button.
Recording will be paused.
5
Press the 0 0 / R R button on the main unit or the TAPE 2 0 0 button
on the remote control to start dubbing.
To stop dubbing:
Press the ■ (TAPE ■) button.
TAPE 1 and TAPE 2 will simultaneously stop.
■
Erasing recorded tapes
1. Load the tape to be erased into the TAPE 2 cassette compartment with the side to
be erased facing toward you.
2. Press the TAPE (1 V 2) button until "TAPE 2" appears on the display.
3. Press the REC PAUSE (I6) button.
4. Press the 0 / R button on the main unit or the TAPE 2 0 button on the remote
control to start erasing.
Note:
Make sure that the TAPE 1 is not in use.
tapes.
2
ENGLISH E-22