Recording to a Cassette Tape from a CD
z When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
z SHARP is not liable for damage or loss of your recording arising from malfunction
of this unit.
z The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
z Do not use metal or CrO tapes for recording.
You can record the desired CD using the DISC 1 - DISC 6 buttons.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button and load the desired disc.
3
Load a cassette into the compartment with side A facing you.
All manuals and user guides at all-guides.com
4
Press the REVERSE MODE button to choose one side or both
sides.
5
Press the REC PAUSE
you record on.
z Recording will be paused.
z To record on both sides, begin on side A. (If recording is started from side B, the
tape will not switch over to side A.)
6
Press one of the DISC 1 - DISC 6 buttons to start recording.
z When the CD reaches the end, recording will stop.
Recording from several CDs continuously:
1 Follow the above steps 1 - 5.
2 Regardless of the setting in step 5, press the
button for side B.
z Recording will start from the disc of the lowest number.
To perform programmed recording:
1 Programme discs and tracks. (See page 17.)
2 Press the REC PAUSE
3 Regardless of the setting in step 5, press the
button for side B.
To stop recording:
Press the
The CD and tape will stop.
Auto restart function:
If the recording side is switched from side A to B during recording, the system will
record the interrupted track on side B from its beginning. The recording will be made
without cutting the beginning of the track on side B.
...
To record on both sides.
...
To record on only one side.
button repeatedly to switch to the side
button.
button.
Programmed Play (See page 17.)
01/1/9
E3.fm
button to record on side A, or the
button to record on side A, or the
ENGLISH
E-29