Listening To A Cassette Tape (Tape 1 Or Tape 2) - Sharp CD-BA3100 Mode D'emploi

Listening to a Cassette Tape (TAPE 1 or TAPE 2)

Before playback:
● For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO tapes are not recommended.)
2
● Do not use C-120 tapes or poor-quality tapes, as they may cause
malfunctions.
● Before loading a tape into the cassette compartment, tighten the slack
with a pen or pencil.
E-19 ENGLISH
■ Sound Control (See page 11.)
Playback is possible in TAPE 1 compartment as well as in TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette door by pushing the area marked " 7 7 PUSH
EJECT".
3
Load a cassette into the TAPE 1 or TAPE 2
cassette compartment with the side to be
played facing toward you.
4
Press the TAPE (1 V 2) button to select the cassette you want to
listen to.
5
Press the 0 R 0/R button to start playback.
When playback is performed using the remote control, press the TAPE 1 or
TAPE 2 0 button.
To stop playback:
Press the ■ (TAPE ■) button.
Fast forward/rewind: (TAPE 2 only)
1. Press the ■ (TAPE ■) button, then press the TAPE (1 V 2) button to select TAPE 2.
2. To advance the tape, press the 2 / 4 button.
To rewind it, press the 3 / 5 button.
Caution:
To remove the cassette, press the ■ (TAPE ■) button, and then open the compart-
●
ment.
Before changing from one tape operation to another, press the ■ (TAPE ■) button.
●
●
If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. Wait until the power is restored.
TAPE 1 TAPE 2