Recording From The Radio; Before Recording - Sharp CD-BA3100 Mode D'emploi

Recording from the Radio

Before recording:

●
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
●
SHARP is not liable for damage or loss of your recording arising from malfunction of
this unit.
●
The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
●
For recording, use only normal tapes. Do not use metal or CrO
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only.
1
Tune in to the desired station. (See page 17.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
tapes.
2
3
Press the REC PAUSE (I I 6) button.
Recording will be paused.
4
0 0 /R button on the main unit or the TAPE 2 0 button on
Press the
the remote control to start recording.
To interrupt recording:
Press the REC PAUSE (I6) button.
To resume recording, press 0/R (TAPE 2 0) button.
To stop recording:
Press the ■ (TAPE ■) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the AM loop aerial.
Erase-prevention tab of cassette tapes:
●
When recording on a cassette tape, make sure
that the erase-prevention tabs are not re-
moved.
Cassettes have removable tabs that prevent
accidental recording or erasing.
●
To protect the recorded sound, remove the tab
after recording.
Cover the tab hole with adhesive tape to record
on the tape without the tab.
■ Listening to the Radio (See page 17.)
/
Tab for side B
Side A
Tab for side A
ENGLISH E-20