8. Align the notches of the spool assembly from which the cutting lines protrude
with the eyelets in the spool retainer, and position the spool assembly into the
retainer with cutting line secured in the eyelets (Fig. 19).
19
Notch
Eyelet
9. Align the release tabs on the spool
retainer with the slots in the upper
cover to mount the spool retainer
onto the upper cover (Fig. 20).
Make sure that the release tabs are
against the upper-cover inside wall
and are exactly located in the slots
on both sides (Fig. 21).
WARNING:
release tabs on the spool retainer snap
into place, otherwise the spool assembly
will come out during operation, which
may result in serious personal injury.
24
56-VOLT LITHIUM-ION REAR-MOTOR 15" STRING TRIMMER — STX3800
Notch
Eyelet
Make sure that the
20
Release
Tab
21
Slot