EGO Power+ STX3800 Guide D'utilisation page 22

◾
Slowly move the trimmer into and out of the area being cut, maintaining the
cutting head position at the desired cutting height. This movement can be either
a forward-backward motion or a side-to-side motion. Cutting shorter lengths
produces best results.
◾
Avoid trimming when grass and weeds are wet.
◾
Wire and picket fences can cause extra string wear or breakage. Stone and brick
walls, curbs, and wood may wear cutting line rapidly.
◾
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can
easily be damaged by the cutting line.
LINE REPLACEMENT
NOTICE: Always use the recommended nylon cutting line with a diameter that does not
exceed 0.105 in.(2.7 mm). Using line other than that specified may cause the tool to
overheat or become damaged.
WARNING:
and become dangerous projectiles.
Trimmer head assembly is shown for reference (Fig. 15a & Fig. 15b).
15a
Flange
Drive Shaft
1. Remove the power plug from the string trimmer.
22
56-VOLT LITHIUM-ION REAR-MOTOR 15" STRING TRIMMER — STX3800
Never use metal-reinforced line, wire, rope, etc. These can break off
Flange Cover
Nut
Upper Cover
Trimmer Line
Spring
Spool Assembly
15b
Washer
Torx screw
Spool Assembly
Spool Retainer
Spool
Bump Feed
Button