Briggs & Stratton 1950 PSI Manuel D'utilisation page 9

8. Start engine according to instructions given in engine
owner's manual.
WARNING
Rapid retraction of starter cord (kickback) will
pull hand and arm toward engine faster than
you can let go.
Broken bones, fractures, bruises or sprains could
result.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
CAUTION
Avoid fire from equipment tip over.
• Always use handle to lift equipment.
• NEVER pull on hoses to move equipment.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
WARNING
Running engines produce heat.Temperature of
muffler and nearby areas can reach or exceed
150°F (65°C).
Severe burns can occur on contact.
Combustible debris, such as leaves, grass, brush,
etc. can catch fire.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
• The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
• Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
How To Stop Pressure Washer
1. Let engine idle for two minutes.
2. Turn engine off according to instructions given in
engine owner's manual.
3. Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury.
BSPP 1950 PSI Pressure Washer
NOTE: A small amount of water will squirt out when
pressure is released.
• Keep high pressure hose connected to pump and spray gun
• Squeeze trigger on spray gun to relieve trapped pressure,
4.
How To Use Adjustable Nozzle
You now should know how to START your pressure
washer and how to STOP it.The information in this
section will tell you how to adjust the spray pattern and to
apply detergent or other cleaning chemicals.
• NEVER adjust spray pattern when spraying.
• NEVER put hands in front of nozzle to adjust spray pattern.
1.
Figure 9 — Adjusting Nozzle for Pressure
Forward = Low Pressure
9
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun retains high pressure when pressure
washer is shut down, which can cause injury.
while system is pressurized.
every time you stop engine. Engage trigger lock on spray gun.
Engage trigger lock on spray gun when not in use.
CAUTION
A pressure washer produces a high pressure spray
which increases risk of injury and damage to unit.
Slide nozzle forward to adjust spray to low pressure
mode (Figure 9). Slide nozzle backward to achieve high
pressure.
and Detergent Mode
Backward = High Pressure
Mode